News — thingiverse RSS

After almost a year of development and refinement we're proud and excited to announce the release of our Entryway Collection.

It's been a year since we launched our Self-Watering Planter (Small) for free on Thingiverse. Since then it's been downloaded over 25,000 times, and has had over 100 makes shared by members of the thingiverse community!

Our Self-Watering Planter is being featured this week on Solidsmack! Check it out here:  Model Of the Week: Self-Watering Planter [It Yo’self!]  There's also some makes of the planter shared from the Thingiverse community. Thanks Josh Ming at SolidSmack!

While there’s lots of tools that everyone will recommend for enhancing your 3D printing experience, there’s a tool at Parallel Goods that we consider indispensable: the Yasutomo Niji Woodcarving set. We use these small hand chisels daily for helping get stuck parts off the bed, cleaning up prints from stringy extrusion anomalies, and occasionally widening the hole on a printed part just enough to give a screw some bite. Everyone on the Parallel Goods team has a set of these chisels, and we all shared a laugh when we realized the first thing we all used our own Push-Pin Organizers for was to hold our chisel sets. Co-founder and Design Lead Craig Stover decided to take his love for these...